Cobblefaced Slab
- Available in: Grey/Charcoal, Tan/Charcoal
- Size 18″ x 18″ x 2 1/4″ (L x W x H)
- No. of Slabs/Pallet 40
- Weight/Slab 58 lbs
- Weight/Pallet 2029 lbs
Brickfaced Slab
- Available in: Tan/Charcoal
- Size 18″ x 18″ x 2 1/4″ (L x W x H)
- No. of Slabs/Pallet 40
- Weight/Slab 58 lbs
- Weight/Pallet 2029 lbs
Slate Slab
- Available in: Grey/Charcoal, Walnut, Buff/Brown
- Size 18″ x 18″ x 2 1/4″ (L x W x H)
- No. of Slabs/Pallet 40
- Weight/Slab 58 lbs
- Weight/Pallet 2029 lbs
40MM Slab
- Available in: Grey
- Size 15 3/8″ x 7 3/8″ x 1 9/16″ (L x W x H)
- No. of Slabs/Pallet 240
- Weight/Slab 14.5 lbs
- Weight/Pallet 3537 lbs
16″ Grey Slab
- Available in: Grey
- Size 16″ x 16″ x 2 1/2″ (L x W x H)
- No. of Slabs/Pallet 60
- Weight/Slab 51 lbs
- Weight/Pallet 3117 lbs
16″ Round Slab
- Available in: Grey, Tan
- Size 16″ Diameter x 2 1/2″ (D x H)
- No. of Slabs/Pallet 60
- Weight/Slab 38 lbs
- Weight/Pallet 2337 lbs
24″ Diamondface Slab
- Available in: Grey
- Size 24″ x 24″ x 1 3/4″ (L x W x H)
- No. of Slabs/Pallet 25
- Weight/Slab 80 lbs
- Weight/Pallet 2057 lbs
24″ Manhatten Slab
- Available in: Grey
- Size 24″ x 24″ x 1 3/4″ (L x W x H)
- No. of Slabs/Pallet 25
- Weight/Slab 80 lbs
- Weight/Pallet 2057 lbs
24″ Manhatten Slab
- Available in: Charcoal
- Size 24″ x 24″ x 1 3/4″ (L x W x H)
- No. of Slabs/Pallet 25
- Weight/Slab 80 lbs
- Weight/Pallet 2057 lbs
24″ Manhatten Slab
- Available in: Brown
- Size 24″ x 24″ x 1 3/4″ (L x W x H)
- No. of Slabs/Pallet 25
- Weight/Slab 80 lbs
- Weight/Pallet 2057 lbs
30″ Diamondface Slab
- Available in: Grey
- Size 30″ x 24″ x 1 3/4″ (L x W x H)
- No. of Slabs/Pallet 25
- Weight/Slab 113 lbs
- Weight/Pallet 2882 lbs
Windsor Slab Size A
- Available in: Charcoal, Tan/Charcoal & Morocco
- Size 8″ x 16″ x 2.5″ (L x W x H)
- No. of Slabs/Pallet 120
- Weight/Slab 25 lbs
- Weight/Pallet 3000 lbs
Windsor Slab Size B
- Available in: Charcoal, Tan/Charcoal & Morocco
- Size 16″ x 16″ x 2.5″ (L x W x H)
- No. of Slabs/Pallet 60
- Weight/Slab 50 lbs
- Weight/Pallet 3000 lbs
Windsor Slab Size C
- Available in: Charcoal, Tan/Charcoal & Morocco
- Size 24″ x 16″ x 2.5″ (L x W x H)
- No. of Slabs/Pallet 40
- Weight/Slab 72 lbs
- Weight/Pallet 2880 lbs
PRODUCT WARRANTY
Product is covered by warranty when the defect is determined to be due to manufacturing processes. Under the event of a defect, the product will be replaced with the same or a similar product. Warranty covers product only. Costs not covered by warranty include but are not limited to labour and installation.
Efflorescence
What is Efflorescence? Efflorescence is a naturally occurring deposit resembling white frost that can sometimes appear on any product made with cement. This includes paving stones, retaining walls, masonry block and even concrete.
This problem can cause some concern for the consumer as it temporarily detracts from the appearance of their project. While efflorescence is a temporary problem it is almost impossible to prevent.
Efflorescence occurs when the water-soluble minerals contained within the product itself, mortar or backfill are dissolved in water. The minerals are then able to migrate from the block to its surface through small pours. When the moisture containing the minerals reaches the surface of the product and evaporates it leaves behind mineral deposits that resemble frost.
Water from sources such as rain, sprinklers even dew can continue to penetrate the product and dissolve minerals, causing the process to start over again for as long as there are free minerals in the product or water is still present.
In climates that experience a lot of rain followed by sun this process will run it course a lot quicker than in semi arid climates where it can take a year or two for the supply of free minerals to be exhausted.
There are a few things that can be done in the mean time while you are waiting for the problem to go away.
- Eliminate the water source if possible. After your Product is dry you can brush the white deposits off with a stiff brush.
- Another option is washing the product off with water, though this can give mixed results. Water applied to the product can dissolve the minerals on the surface and pull them back into the product as it soaks up the water causing the process to take longer.
- The last way to deal with the problem involves washing the product with a week solution of muriatic acid. This solution however comes with several problems. Any acid can pose a risk to the person applying it to the product. All safety and environmental factors must be taken into account before using this method. The last problem with using acid is that it actually changes the surface of the product and in doing so cause the color to change as well.
In closing, it is our recommendation that you allow nature to take its course. The disappearance of the efflorescence will occur in its own time.